| PERFORMANCE IMPROVEMENT |
|
WEIGHT REDUCTION
Weight reduction is a most important issue for aerospace applications. Composites are widely used on structures which require smooth surface finish. Commonly, fillers and putty are used to level the undulations/matty texture of composite surfaces. These materials add to the weight of the structure which is undesirable. We have introduced a low density ( SG of 0.95, lighter than water) Primer cum Filler ( MPC 50015/50019 ) for composites of Advanced Light Helicopter which resulted in weight reduction of about 30% when compared to the earlier products. |
|
|
|
Two composite panels before coating
a. Resin starvation area and
b. matty texture are seen
|
Same panels after MPC 50019
have smooth surface finish |
|
THERMAL MANAGEMENT
We provide thermal management solutions for reducing heat losses, thermal shield, minimizing solar heat absorbtion and controlling emissivity of material surfaces. |
|
|
|
Thermal insulation of ECS hoses |
SHR reflection paints |
|
| IMPROVEMENT OF HIGH TEMPERATURE CORROSION |
|
|
|
|
|
| Gas turbine components
life extended with diffusion coatings |
|
Distortion and puncturing of heater tubes attributed to carbon diffusion and thermal cycling. MCC 1000 coatings implemented for enhancing life |
|
|
|
| |
 |
